Short update, KVM setup changed a bit in the last months.
First, when working with Raspberry camera connected to Pi5 it turned out to be helpful to hang the Pi5.
Initially at small black cable, today replaced with nylon cable.
Later I bought a 2nd GS camera for stereo high framerate recording, and 3Dprinted PT stereo cameras stand:
https://www.printables.com/model/790362 ... oldermount
The two Raspberry GS cameras (both with official Raspberry 6mm lenses) are connected with two 300mm flat ribbon cables to Pi5.
On 3/8 I completely lost SDcard that was new when I got my Pi5 early December last year.
That was the point I decided to go with NVME SSD (I had a spare unused Crucial P3 500GB available).
I installed OS on new SD card on 3/8 and wanted to start fresh with new OS on NVME SSD.
So I wanted to get it quickly and not wait until end of April for official NVME hat.
Therefore I bought the Pimoroni NVME base, which arrived today:
https://shop.pimoroni.com/products/nvme ... 9587178579
Cheap, no conflict with active cooler, and shipping from UK to Germany not more expensive than from German reseller.
Finally I decided to clone SD card option listed in well written doc:
https://learn.pimoroni.com/article/gett ... on-options
12MP smartphone photo: https://stamm-wilbrandt.de/en/forum/IMG ... 157_MP.jpg
[the Raspberry mouse is working, allows to keep working when wireless MX Ergo trackball needs to be recharged (seldom)]
P.S:
I had problems to use MX Ergo trackball via Pi5 Bluetoth, so Bluetooth is turned off.
I had no idea where the small Logitech dongle was, finally found it here [there are so many available USB (2.0) ports]:
First, when working with Raspberry camera connected to Pi5 it turned out to be helpful to hang the Pi5.
Initially at small black cable, today replaced with nylon cable.
Later I bought a 2nd GS camera for stereo high framerate recording, and 3Dprinted PT stereo cameras stand:
https://www.printables.com/model/790362 ... oldermount
The two Raspberry GS cameras (both with official Raspberry 6mm lenses) are connected with two 300mm flat ribbon cables to Pi5.
On 3/8 I completely lost SDcard that was new when I got my Pi5 early December last year.
That was the point I decided to go with NVME SSD (I had a spare unused Crucial P3 500GB available).
I installed OS on new SD card on 3/8 and wanted to start fresh with new OS on NVME SSD.
So I wanted to get it quickly and not wait until end of April for official NVME hat.
Therefore I bought the Pimoroni NVME base, which arrived today:
https://shop.pimoroni.com/products/nvme ... 9587178579
Cheap, no conflict with active cooler, and shipping from UK to Germany not more expensive than from German reseller.
Finally I decided to clone SD card option listed in well written doc:
https://learn.pimoroni.com/article/gett ... on-options
12MP smartphone photo: https://stamm-wilbrandt.de/en/forum/IMG ... 157_MP.jpg
[the Raspberry mouse is working, allows to keep working when wireless MX Ergo trackball needs to be recharged (seldom)]
P.S:
I had problems to use MX Ergo trackball via Pi5 Bluetoth, so Bluetooth is turned off.
I had no idea where the small Logitech dongle was, finally found it here [there are so many available USB (2.0) ports]:
Statistics: Posted by HermannSW — Tue Mar 19, 2024 8:01 pm