I'm using single addressable led SK6812MINI-E http://yushakobo.jp/ds/YS-SK6812MINI-E.pdf and I was wondering if the pin that goes from a RP4 GPIO PIN to the DATA port of the led needs to be pulled up or down with a resistor, cause the data port on the led is the one receiving the high (3v) o low (0v) signal right?, and since the gpio pins are on a floating state without a resistor, I could see the led turning on and off or have trouble turning it on and off, I still haven't soldered one but I was just thinking about it
Statistics: Posted by danilux — Sun Jun 16, 2024 6:02 am