I've been trying to get a camera module 3 connected to my pi5, and have run into some errors that seem to indicate that the camera is not being recognised. Initially I ran 'rpicam-hello' and the preview window appeared properly, but a few minutes later I tried the command again and got a few errrors about the camera frontend timing out. I tried checking the connections to the cable and plugging everything in again, got the same errors about the timing and then eventually the camera was not detected at all (I ran 'rpicam-still --list-cameras' and got an output of no cameras detected where previously there was one). I get the error of no cameras detected for both of the connectors on the pi.
I'm using the pi5 with a keyboard and a monitor, and have attached pictures of the camera and connector cable below. I'm confused as to why it suddenly stopped working when it was previously, any assistance on this matter would be appreciated. Thank you.
I'm using the pi5 with a keyboard and a monitor, and have attached pictures of the camera and connector cable below. I'm confused as to why it suddenly stopped working when it was previously, any assistance on this matter would be appreciated. Thank you.
Statistics: Posted by lucas_c — Tue Jul 09, 2024 12:22 pm