I didn't think about attaching wires. I'll try that tomorrow. I guess I can bring the wires over to a breadboard and then get the debug probe hooked up over there. I think my iron is set as cool as I can manage. I was using about 300-310C. The issue I was having seems to be that it's tough to get the iron at an angle where it can heat the pads properly because there is not much clearance between the wireless chip and the SWD socket. (I am also a novice solderer.)
Thank you for explaining that the pads go all the way through the device. I take it I'd need to use solder paste and possibly an oven to reflow paste onto the pads?
Statistics: Posted by jags84 — Tue Apr 30, 2024 4:50 am