I have been using Silcone sealed keyboards in my CNC workshop for decades.
I collected a bunch, never used, still in the box/tube when they went on special for $6.
Ok for starting and stopping G-code, not for typing a word doc.
Was always some risk of getting metal swarf in finger tips when using them![;)]( "Wink")
Enclosed CNC machines are good OH&S.
Now relearning Pi4 full size keyboard skills on a $6 keyboard that was not on special![;)]( "Wink")
It is better than Pi400 keyboard but it is not a mech clickety clack one.
If a Pi500 shows up will I tolerate a tiny membrane keyboard again?
I collected a bunch, never used, still in the box/tube when they went on special for $6.
Ok for starting and stopping G-code, not for typing a word doc.
Was always some risk of getting metal swarf in finger tips when using them
Enclosed CNC machines are good OH&S.
Now relearning Pi4 full size keyboard skills on a $6 keyboard that was not on special
It is better than Pi400 keyboard but it is not a mech clickety clack one.
If a Pi500 shows up will I tolerate a tiny membrane keyboard again?
Statistics: Posted by Gavinmc42 — Sat Jan 06, 2024 3:57 am